Welcome To APC Industries ! ---------- Contact Us

这是描述信息
这是描述信息
这是描述信息
这是描述信息
APC Industries
Check category

General principles of ANSI Y strainer threaded product selection

2021-10-13 14:41

The ANSI Y strainer threaded manufacturer tells you that it is used on the filter performance test bench. This test bench must strictly purify the system before the test. Therefore, the test system and the pollution injection system serving the test system must be equipped with filters. The medium filter and the tested filter are two different things. The ANSI Y strainer threaded manufacturer tells you its accuracy requirements. The dirt holding capacity requires higher accuracy than the tested filter, in order to distinguish the two types of filters in the same test system. This kind of filter is called the test bench filter, and the tested filter is called the tested filter.

Cheap ANSI Y strainer threaded products
General principles of ANSI Y strainer threaded selection:
1. Import and export path:
In principle, the inlet and outlet diameter of the filter should not be smaller than the inlet diameter of the matching pump, and it is generally the same as the inlet pipe diameter.
2. Nominal pressure:
Determine the pressure level of the filter according to the highest pressure that may appear in the filter line.
3. Selection of the number of holes:
The ANSI Y strainer threaded manufacturer tells you that the main consideration is the particle size of the impurity that needs to be intercepted, which depends on the process requirements of the medium. The particle size that can be intercepted by various specifications of screens can be found in the following table "Filter Specifications".
4. Filter material:
The material of ANSI Y strainer threaded is generally the same as the material of the connected process pipe. For different service conditions, you can consider choosing a filter made of cast iron, carbon steel, low alloy steel or stainless steel.
5. Calculation of filter resistance loss
The ANSI Y strainer threaded manufacturer tells you that the water filter has a pressure loss of 0.52~1.2kpa under the general calculation of the rated flow rate.
The above is the general principle of ANSI Y strainer threaded product selection, I hope it will be helpful to you.

CUSTORMER MESSAGES

Username used for comment:
Customer message
Description:

No. 18 Taishan Road, Ningjin County, Shandong Province P.R.China

Mobile:+8618600252968

© 2019 NingJin APC Industries Co.,Ltd. All Rights Reserved 鲁ICP备12020262号 Powered by www.300.cn

这是描述信息

QR code